Modem Products

Home | Profile | Products | Prices |  Contact Us
PC/104 MODEM
#8510R6S #8510R6SZ

RoHS COMPLIANT

56,000 bps Modem for full duplex operation over the Public Switched Telephone Network (PSTN)
  • Functionally and Electrically 8 Bit PC/104 Bus Compatible (16 bit pass-through option available)
  • Standard "AT" Command Set Including "S" Registers and Result Codes
  • Auto/Manual Answer or Dial
  • Detects Busy, Ring, Dial Tone, Carrier
  • Type I and II caller ID (CID) decoding 
  • 63 embedded and upgradeable country profiles
  • Worldwide compliance
  • DTMF and Pulse Dial
  • RJ-11 6-position Modular Jack. (may be ordered with extension phone jack and disconnect circuitry)
  • Complete "&T" testing capability with Loop-back/Memory Test
  • Supports ECC: V.42/MNP 4 / MNP 2 Error Correction. V.42NV.42 bis/ MNP 5 Data Compression. 
  • Non-volatile RAM for user phone directory and stored operating profiles.

  • Data Rate: Modem #8510 - send to 48,000 (V.92) 33,600 (V.90) bps, receive up to 56,000 bps  
  • Compatibility:  Modulations and Protocols: 
                 ITU-TV.92: Modem-on-Hold (MOH) · Quick Connect (QC) · PCM upstream
                 V.90/V.34/V.32bis/V.32  V.22bis/V.22/V.23V.21 v.23 reverse, V.23 half-duplex 
                 Bell 212A/Bell 103 V.80 Synchronous Access Mode 
  • Operational Modes: Full or Half Duplex, Auto Dial, Auto Answer, Auto Redial, Tone or Pulse
  • Internal Telephone Number Directory: Supports 4 saved numbers of 35 characters each. 
  • Dialing: DTMF - in accordance with ITU-T Q.23,  Pulse: in accordance with EIA/TIA-496-A Blind - by command
  • Ringer Equivalence: 0.6B
  • Command Buffer: 40 Character
  • Host Interface: PC/104 pass-through connector for 8 bit bus 
  • Telephone Interface: RJ-11C line jack (only Tip & Ring required)
  • Command Set: Full AT including Extended Commands, S Registers, Result Codes
  • Size & Weight: 3.55 x 3.775 x 0.55 in (90 x 96 x 14mm), 1.39oz (45gm)
  • Line Impedance: 600 ohms, ±10%
  • Power – Full Config:  Off Hook: 5V ±10% typ 140mA Idle: 5V ±10% typ 120mA Sleep Mode: 5V ±10% typ 55mA 
  • Environmental Specifications
  • - Operating Temperature: 0°C to +70°C (32°F to 158°F)
  • - Storage Temperature: -55°C to +125°C (-67°F to +257°F)
  • - Relative Humidity: Up to 90% noncondensing, or wet bulb temp to 35°F, whichever is less 
  • - Extended Temp Version:-40° to +85° C, 0-90% RH noncondensing

Options
 
    -2
Extension phone jack
 
         -EXT
Extended temperature from -40° to 85° C, 0-90% RH noncondensing
 
         -J2
PC/104 16 bit J2 pass-through connector
 
         -COM X Four additional non-standaed COM Ports
         -SP Speaker
    -XB
MAXSTREAM XBee TM RF MODULE (ZigBee TM    IEEE ® 802.15.4)
 

Option Prices
Home | Profile | Products | Prices |  Contact Us
Copyright 1997-2008 Aprotek All Rights Reserved
Oregon USA, Phone: 541-582-2120 Fax: 541-582-2149
E-mail: aprotek@aprotek.com